Page 1 of 1
How to display the report only after search
Posted: Fri Oct 04, 2013 7:55 pm
by fredtma
Hello,
I have a large data to filter, i do not want the report to run the entire report immediately.
The user should add a couple of filter before the report runs is there away to do that?
Re: How to display the report only after search
Posted: Sat Oct 05, 2013 10:00 am
by Webmaster
If you are talking about reports in PHPMaker, that is not supported.
If you are talking about PHP Report Maker (assume you posted to wrong forum), just enable "Requires Search Criteria", see Table Setup in the help file.
Re: How to display the report only after search
Posted: Wed Oct 09, 2013 4:44 pm
by fredtma
Thanks, that's what I needed